BLYSK Bare Metal Seam Sealer Gray SS10 - Two-Part, Semi-Flexible, Non-Sagging

BLYSK Bare Metal Seam Sealer is a semi-flexible, non-sagging, high-strength sound deadener/seam sealer with excellent adhesion to SMC, FRP, fiberglass, aluminum, bare metal, primed or painted surfaces, and most plastics. Used for sealing vertical & horizontal seams and joints.

DIRECTIONS 

1. Surface must be clean and free of dirt, grease, oil, rust, old seam sealer, and any other contaminants. 

2. Apply directly to bare metal, epoxy or urethane-primed surface. 

3. Follow the BLYSK dual cartridge setup instructions for loading the cartridge into the dispensing gun. 

4. Dispense BLYSK Bare Metal Seam Sealer into the joint or seam. Smooth out if desired with a tool, finger or brush. 

5. BLYSK Bare Metal Seam Sealer will be set up in approximately 10 minutes. 

6. Scuff or sand sealer with 320 grit sandpaper prior to priming or painting. 

7. Prime and paint per manufacturer’s specifications.

PROPERTIES 

Mixed Color Various 

Mix Ratio 1:1 

Work Time 10-15 Minutes 

Handling Time 20-30 Minutes 

Part Paintability 45 Minutes 

Sealer Sandability 45 Minutes 

Full Cure Strength 6-8 Hours 

1500-Hour Salt Fog Test Passed

CAUTION 

For professional use only. Before using this or any BLYSK product, refer to the Safety Data Sheet (SDS) and label it for safe use and handling instructions. 

STORAGE

Should be stored in a cool, dry location at a temperature between 50°F to 86°F (10°C to 30°C).