BLYSK Super Bond 90 Plastic Adhesive PR1.5 Two-Part Fast-Set Plastic Bonding Adhesive

BLYSK Super Bond is a fast-set plastic bonding adhesive used for bonding & repairing small panels, bumper tabs, headlamp buckets, header panels, etc. Use on small panels, bumper tabs, headlamp buckets, header panels, grills, consoles, armrest supports, and much more! Our automatic mixing system eliminates errors that are common in manual mixing.

 Includes:

2 Epoxy Mixing Nozzles

DIRECTIONS 

1. Clean surface.

2. Sand all paint off of the surface to be repaired. Blow off with clean compressed air. 

3. Insert the cartridge into a manual dispensing gun and remove the cap.

4. Squeeze out a small amount of material until you see the repair compound freely flowing from both sides of the cartridge. 

5. Attach the mixing tip. Pump the gun and squeeze out a couple of inches of repair compound, ensuring an equal mix. 

6. Dispense and spread the adhesive onto the surfaces to be bonded. Assemble immediately and clamp. 

7. Repair compound will begin to gel in 1-2 minutes. 

8. Sand and finish as needed.

USES 

Small Panels 

Bumper Tabs 

Headlamp Buckets

Header Panels 

Grills 

Consoles 

Arm Rest Supports

And much more!

PROPERTIES 

Mixed Color: Black 

Mix Ratio: 1 to 1 

Work Time: 1-2 Minutes 

Handling Time: 5-10 

Clamp Time: 10-15 Minutes 

Sandable: 30 Minutes 

Paintable: 30 Minutes 

Full Cure Strength: 24 Hours 

VOC 0% 

CAUTION 

For professional use only. Before using this or any BLYSK product, refer to the Safety Data Sheet (SDS) and label it for safe use and handling instructions.